Product Description

Brand: Hikvision

Product Code: Hikvision 4Channel Dvr 4MP (DS-7204HQHI-K1

Product Description

• 4 Turbo HD/CVI/AHD/CVBS self-adaptive interfaces input, 4-ch video&1-ch audio input, 1-ch IP video input, H.265/H.265+ compression, 1 SATA interface,CH01: 3MP @ 15fps, CH02-04:1920×1080P/4MP Lite @15 fps/ch, support CVBS output, standalone 1U case, Network interface:1 RJ45 100M,eSATA:N/A
• 265 Pro+/H.265 Pro/H.265/H.264+/H.264 encoding for the mainstream, and H.265/H.264 for the sub-stream of analog cameras
• Self-adaptive HDTVI/HDCVI/AHD/CVBS signal input
• Connectable to H.265+/H.265/H.264+/H.264 IP cameras
• Up to 4MP lite resolution for recording
• HDMI output at up to 4K (3840 × 2160) resolution for DS-7216HQHI-K1
• Long distance transmission over UTP and coaxial cable
• 4/8/16-ch synchronous playback

Connection to the internet is a breeze with the Hik-Connect Setup without any technical or port forwarding knowledge or expertise required.

FREE iPhone, iPad, Android, PC & MAC remote viewing software (iVMS 4200 & Hik-Connect)

This DVR will ship with the latest Firmware pre-installed and fully tested ready for immediate use

Key features:

• HD-TVI video recording resolution: 1080p, 720p at 15 fps, WD1 and lower resolutions at 25 fps,
• Recording resolution of HD-CVI, AHD video: 2 MP at 15 fps
• Channel 1 additonally supports the recording resolution of 3 MP at 15 fps,
• 1080p lite recording mode: 960×1080 at 25 fps,
• Support for 4 HD-TVI, AHD or CVBS cameras and one IP camera (Hikvision or others by Onvif, max. 4 MP),
• Analog channels can be replaced with IP channels in a 1:1 ratio,
• Enhanced IP mode (interferes with VCA functions): 2 IP channels (6 with the analog channels switched off),
• H.265 and H.265+ video compression,
• Support for IE,
• Channel 0 – possibility to monitor all cameras with minimum demand for network bandwidth,
• Parallel operation of HDMI and VGA outputs up to 1920 x 1080 pixels,
• CVBS output,
• Searching recordings by alarm events,
• VCA image analysis function,
• Digital video zoom during live monitoring and playback,
• Synchronous playback from 4 channels,
• Support for IPv4, IPv6,
• Monitoring the statuses of LAN, cameras, hard drives

Hikvision DS-7204HQHI-K1 is a 4-channel CCTV DVR capable of recording surveillance video provided in HD-TVI, HD-CVI, AHD, CVBS and IP standards with the resolution of 1080p/720p at 15fps. Channels 1, however, can also support 3MP@15fps. For VGA/WD1/4CIF/CIF resolutions, the maximum frame rate is 25 fps

H.265 video compression

The DVR can record one or two video streams (primary and/or secondary) from each channel. The video can be compressed using the H.265 method. Compared with its predecessor (H.264), H.265 can reduce the data stream by half, which translates into proportional disk space savings and extended data retention time. H.265+ can further minimize the streams in typical video surveillance scenarios.

Special recording modes

Footage can be recorded in different modes: continuous, motion detection (with pre- and post-event recording), alarm (with pre- and post-event recording), or continuous recording with special parameters for specific events. Each channel can be configured individually in this respect. It is possible to change the resolution, quality, and frame and bit rates independently of the continuous recording settings. After the occurrence of an event (motion detection, camera tampering, etc), the DVR automatically switches to the event-recording mode (usually with higher parameters). During the rest of the time the recording is carried out in the continuous mode. The increased parameters just before and after the event allow to play back every second with high detail and smoothness, while the recordings between events may have a much lower performance, taking significantly less storage media space.

Enhanced IP mode

The Enhanced IP mode allows to increase the number of supported IP channels. It disables smart events in analog channels and limits the HDMI/VGA output resolution to 1080p. The mode can be activated only through direct access to the DVR’s menu.

Intelligent image analysis

Each channel can be independently set up for motion detection and VQD (video quality detection, which e.g. can send e-mails or notifications to alert the user whenever the image is out of focus, too bright, or discolored).
Two analog channels can be selected to detect virtual line crossing (and its direction) and intrusion within a rectangular area.
Users can also opt for the Enhanced VCA mode, in which virtual line crossing and intrusion detection are available in four channels. If the mode is switched on, the CVBS output will be disabled.

Sophisticated client software

The iVMS 4200 client software enables users to manage Hikvision devices in IP networks. The software enables the configuration and management of NVRs/DVRs, IP and analog cameras in hybrid systems. The iVMS 4200 utility can remotely manage up to 256 devices on up to 4 monitors. One monitor can display images from up to 64 cameras. Aside from system configuration and live monitoring, the utility can be used for remote playback, notifications, two-way audio transmission, and multi-level e-maps.

• 265 Pro+/H.265 Pro/H.265/H.264+/H.264 encoding for the mainstream, and H.265/H.264 for the sub-stream of analog cameras
• Self-adaptive HDTVI/HDCVI/AHD/CVBS signal input

Connectable to H.265+/H.265/H.264+/H.264 IP cameras

SADP (Search Active Device Protocol) is a free, easy-to-use utility designed to search for Hikvision IP cameras and DVRs/NVRs in the local network. The network device search tool can also be used to modify device network parameters, e.g. to change or recover default passwords. Detailed information on the software and its use can be found in the following article:

Specifications: